Shahram Nazari; maryam hossieni; Mehrzad Allahgholipour
Abstract
In order to investigate the effect of seed priming (pretreatment) and coating on seedling characteristics, root morphology and phenological stages of rice, a two-year experiment has been conducted in the Rice Research Institute of Iran (Rasht) between 2020 and 2021. The experiment is performed as a factorial ...
Read More
In order to investigate the effect of seed priming (pretreatment) and coating on seedling characteristics, root morphology and phenological stages of rice, a two-year experiment has been conducted in the Rice Research Institute of Iran (Rasht) between 2020 and 2021. The experiment is performed as a factorial in a randomized complete block design with three replications. Experimental factors include two rice cultivars (Hashemi and Gohar) and the seed pretreatment of rice cultivars in seven levels, including (1) priming with calcium chloride (-1.25 MPa in 24 hours), (2) priming with potassium chloride (1.25 MPa in 24 hours), (3) priming with zinc sulfate (concentration of 0.5 mM in 12 hours), (4) hydro-priming (48 hours) + coating the seeds with calcium chloride, (5) hydro-priming (48 hours) + coating with potassium chloride, (6) hydro-priming (48 hours) + coating with zinc sulfate, and (7) hydro-priming (48 hours as control). The results show that the highest percentage and germination rate has been observed with 99.5% and 0.23 seeds per day under seed priming with potassium chloride in the Gohar cultivar, respectively. The lowest time required to achieve 90% emergence has belonged to Hasehmi and Gohar cultivars through priming with potassium chloride and calcium chloride. The highest root length (with 24.6 cm) has been observed in priming with potassium chloride in the Gohar cultivar. The highest root dry weight in Hashemi and the Gohar cultivars has been 2.14 and 4.9 g, respectively, in priming with potassium chloride. The results also show that the maximum root volume and area are obtained with 43 cm3 and 155.28 cm2 in priming with potassium chloride in Gohar cultivar, respectively. The least time required to achieve maximum tillering, 50% flowering, and physiological maturation takes place in priming treatment with calcium chloride and potassium chloride. Seed priming with potassium chloride and coating with calcium chloride have increased grain yield by 22% and 13%, respectively, compared to the control. The highest biological yield is observed in potassium chloride priming and coating with calcium chloride treatments with 5552 and 5414 kg. ha-1 in Gohar cultivar, respectively. In general, rice seed priming with calcium chloride and potassium chloride promoted plant yield by improving seedling characteristics, root system, and phenological stages.
Mehdi Esmaeiltabar; Faezeh Zaefarian; Shahram Nazari; Rahmat Abbasi
Abstract
In order to investigate the effect of different weed control managements on emergence characteristics and morphological growth of rice seedlings in the seedling stage in a direct seeding system, a field experiment has been conducted in the 2020 growing season, Babolsar, Bahnemir, Iran. Being a factorial ...
Read More
In order to investigate the effect of different weed control managements on emergence characteristics and morphological growth of rice seedlings in the seedling stage in a direct seeding system, a field experiment has been conducted in the 2020 growing season, Babolsar, Bahnemir, Iran. Being a factorial in a randomized complete block design with three replications, the experiment employs the following treatments: Shiroudi, Khazar, and Hashemi cultivars as well as various weed control management in five levels of seed coating with calcium chloride, seed coating with potassium chloride, weeding, chemical control, and control. The interaction effect of weed management and cultivar shows that coating the seeds with calcium chloride, potassium chloride, and weeding cuts the dry weight of grasses by 55%, 68%, and 85% in Shiroudi cultivar, by 79%, 63%, and 54% in Khazar cultivar, and 30%, 58%, and 35% in Hashemi cultivar, respectively, compared to the control. The maximum percentage of germination with 99%, 97%, and 95% belong to seed coating with potassium chloride, calcium chloride, and weeding in Shiroudi cultivar, respectively. The highest germination rate could be observed in potassium and calcium chloride seed coating treatments and weeding. The lowest density of broadleaf weeds with 0.91 plants m-2 is obtained in Shiroudi cultivar and by managing the seeds coating of this cultivar with calcium chloride. The highest seedling length and weight vigor indices are obtained with 3559 and 137 in Shiroudi cultivar under weeding management, respectively. Results show that seed coating improves the seed yield of rice cultivars.
Mohammad Khademi; Faezeh Zaefarian; Shahram Nazari; Mohammad Ali Esmaeili
Abstract
To investigate the effect of seed priming on emergence characteristics, root morphological growth, and phenological trends of rice in direct seeding, an experiment has been conducted in Sari Agricultural Sciences and Natural Resources University within 2019. The study is conducted as factorial in a randomized ...
Read More
To investigate the effect of seed priming on emergence characteristics, root morphological growth, and phenological trends of rice in direct seeding, an experiment has been conducted in Sari Agricultural Sciences and Natural Resources University within 2019. The study is conducted as factorial in a randomized complete block design with three replications. The factors include Tarom Hashemi and Shiroudi cultivars and priming at five levels, namely hydropriming (for 48 hours), calcium chloride, and potassium chloride priming (Ψs -1.25 MPa), ascorbate acid (10 mg l-1), and control (no priming). The effect of priming on emergence percentage shows that the highest amount of this trait belongs to 90% in priming with calcium chloride, which is not significantly different from priming with potassium chloride and water. The rate of emergence of priming with calcium chloride, potassium chloride, and water has increased by 50%, 36%, and 29%, respectively. Results show that priming with calcium chloride, potassium chloride, ascorbate acid, and water has increased by 55%, 50%, 33%, and 38% of the plant height and by 48%, 29%, 12%, and 25% of plant dry weight, respectively. In Shiroudi and Tarom Hashemi cultivars, the time required for the onset of tillering has been 27.40 and 24.53 days; panicle appearance, 90.4 and 53.87 days; flowering, 100.53 and 70.87 days; and maturity 132.26 and 94.61 days, respectively. The least time required for panicle appearance and flowering is observed in priming with calcium chloride, although this has not been significantly different from other priming, and decreased by 11.17 and 7.5 days to the control, respectively.
Ali Akbar Ghasemi; Hassan Hamidi; Jaber Arves; Ali Masomi
Abstract
In order to study the effects of salinity stress (made by sodium chloride and calcium chloride) andtemperature interaction on germination characteristics of hyssopus officinalis, an experiment was conducton factorial basis and in a completely randomized design with three replication at laboratory of ...
Read More
In order to study the effects of salinity stress (made by sodium chloride and calcium chloride) andtemperature interaction on germination characteristics of hyssopus officinalis, an experiment was conducton factorial basis and in a completely randomized design with three replication at laboratory of KhorasanRazavi Agriclultural and Natural Resource Research Center in 2010. In this experiment, different osmoticpotentials (0, -3, -6 and -9 bar) and also different temperatures (20, 25, 30 and 35 centigrade degree) wereused. In this research, the percentage and rate of germination, the length of radicle and plumule, lengthratio of radicle and plumule and seed vigor characteristics has been measured. The results showed a verysignificant effect of salt levels, osmotic potential and temperature on the above characteristics. The meancomparison for percentage and rate of germination characteristics showed that calcium chloride with 63%and 7.11 respectively had a significant difference with sodium chloride with 50% and 1.70. The highestpercent and rate of germination were seen in -3 bar osmotic potential made by calcium chloride in 25centigrade degree. The highest length of radicle and vigor was in -3 bar osmotic potential made bycalcium chloride in 20 centigrade degree. The highest length of plumule was seen in both sodium chlorideand calcium chloride in 0 bar (control) osmotic potential and 30 centigrade degree. Generally while theosmotic potential increases and temperature goes up to 30 centigrade degree all the characteristics insodium chloride and calcium chloride had a remarkable reduction. Also increment of high temperatureshad more harmful effects in NaCl than CaCl2. Study the Hyssop plant response to different levels ofsalinity and temperature on germination stage, it will assist farmers in establishment and desirableproduction.